Zeitronix nDash Touch Screen Display plus Zt-2 Wideband O2 Sensor Data Log OBDII

Description: Zeitronix nDash Display Includes: NDash display, cables, license Zeitronix Zt-2 Wideband Oxygen Sensor & Datalogging System nDash display features: Zeitronix nDash display is Preconfigured for easy Plug and Play use with the Zt-2 Display and data log AFR, RPM, EGT, Vacuum/Boost, TPS, and configurable User Inputs - additional sensors required unless input comes from OBDII - sensors not included, available separately 4.4" Touch-Screen offers 480x272 resolution using TFT LCD technology 24-bit full color display with contrast ratio of 350:1 Dimensions are 5” x 3” x 0.75”, weight is only 0.5 lbs, (127mm x 77mm x 19mm, 275 grams) Full OBDII support for display of parameters such as Mass Air Flow, Spark Advance, Coolant Temperature, and many more! (OBDII is not required for use with the Zt-2) Generic OBDII, Enhanced Ford, Chrysler and GM drivers. For additional two channels nDash analog inputs are mapped to Zeitronix sensors - sensors not included, available separately Data logging support onto removable memory card - no laptop or PDA required. (memory card not included) Auto Adjusting backlight, night mode, and low power standby. Calculate Horsepower, Torque, 0 to 60 Performance, MPG and set configurable trip counters. Diagnose and clear check engine light error codes. OBDII and Plug and Play Zeitronix Zt-2 cables included. nDash Zt-2 license included Simple and secure windshield-mounted display. Zt-2 Wideband O2 Sensor System features: Includes the Zt-2 Model 2010 Wideband Air/Fuel Ratio Meter, Wideband Oxygen Sensor, Sensor Harness, Signal Harness, PC Serial Cable, Datalogging Software, Installation Instructions and 2-Pin EGT Connector to retrofit your EGT probe. Data splitter included for simultaneous display and datalogging use. Made in the USA. The Zeitronix Wideband Air/Fuel ratio meter and datalogging system is a high quality, stand-alone system for use with carbureted and electronic fuel injection engines. Zt-2 Wideband Kits provide the best bang for your buck delivering unmatched quality, features and capabilities for very reasonable prices. The Zeitronix system provides the accuracy of a Dyno Air/Fuel reading right in your vehicle as well as multiple engine parameters. Supports Air/Fuel ratio as AFR/Lambda, plus RPM, Vacuum, Boost, Exhaust Gas Temperature, Throttle Position, 0-5 volt sensors, and Air/Fluid temperature sensors. Tune fuel injected and carbureted engines. Very simple installation. Connect two wires to +12V and ground and place the O2 sensor in the exhaust stream and you are ready to read AFR! Cut your tuning time in half! Finally you can tune for more power, closer to the edge, precisely monitoring Air/Fuel ratio Boost, EGT, RPM and throttle position datalogging up to 9 hours of data with a blazing rate of 74 samples per seconds per graph. The ZDL software can be utilized as a real time display when using a basic Zt-2 kit without the hardware display. Fully digital, smallest wideband O2 controller and datalogging system in the world! Zt-2 is about the size of 1" thick business card. Extremely compact design for installation where space is a premium. Zt-2 Specs: 0.1 AFR accuracy Operating voltage 10V to 18V Switching power supply for oxygen sensor heater Precise sensor temperature control Reverse polarity protection Integrated self resettable fuse Positive lock connectors Protected inputs and outputs Flexible Plug and Play Sensor Harness with a small, easy to route through the fire wall, connector Wideband Oxygen Sensor included Easy to install plug and play kit Adjustable Narrowband Switching Point Warning Alarms and Triggers Your laptop must have a serial port or a USB to serial port adapter, adapter is included! Inputs/Outputs: Bosch Wideband O2 sensor Linear Wideband Output AFR=Vx2+9.6 Serial data output to the Zeitronix Wideband LCD Display Serial data output for real time datalogging (PC laptop required) RPM Input (tachometer, primary side ignition coil, crank, cam sensor). The RPM input works in any car and any ignition system. No additional adapters needed! Simulated and adjustable Narrowband Output to feed a stock ECU Throttle Position Input Boost (MAP) Sensor Input EGT Probe Input User Input User2 Input, Programmable to view/log 0-5V, Fuel Pressure, Oil Pressure, Boost Pressure, Water Temperature, Intake Air Temperature, Oil Temperature, Transmission Temperature. (Zt-2 model 2010- viewing supported in new LCD, ZR-2 gauges, and logging software) Warning Output * 5V output for sensors Click here to shop my store! Purchase details: eCheck payments wait to ship until the eCheck clears, per PayPal instructions International buyers pay import duties / customs feesSales tax is collected for most states, please review your total purchase amount before committing to buy My name is Chris and I sell on eBay using the golden rule: treat others as I'd want to be treated (and it's worked so far: look at my feedback since 1999 on eBay). I'm happy to answer any questions. I want each transaction to go smoothly!

Price: 819.99 USD

Location: Canton, Georgia

End Time: 2024-08-12T22:37:09.000Z

Shipping Cost: N/A USD