Description: This is a custom 3D Printed Wall Mount Holder Bracket for the DeWalt DCS565 Circular Saw (6.5")Screw the two pieces into the wall with a 10" gap between them. Slide the top of the plate of the saw all the way up into top piece, rotate the bottom of the saw in between the two, and then lower it into the lower piece. The screw holes are designed assuming the bottom of the heads of the screws are flat (e.g. pan head, round head, hex washer, etc.). The screws should have shafts that fit through a 5mm diameter hole, and have a head with a diameter larger than 5mm and smaller than 10mm. (I'm making this sound complicated, but most screws for wall mounting, including nearly any that come with wall anchors, will meet these requirements) Strong one piece design that is, chemical, heat, impact, and UV resistant Simple and effective, easy to mount anywhere
Price: 17.69 USD
Location: Little York, Illinois
End Time: 2024-12-05T02:56:42.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: DNA
