Description: PINK PMMANOBILCAM Pink PMMA DiscNOBILCAM Pink PMMA Discs are used for the fabrication of the digital denture base, which could simplify the process of making full dentures.Below is th link of how to make digital denture base: https://www.youtube.com/watch?v=G2GtBtE2X_U Advantages• Suitable material for milling a denture base• Easy to operate, stable and low water absorption• Excellent biocompatibilityIndications• Digital denture baseTechnical ParameterPropertiesParameterFlexural strength>120 MpaModulus of Elasticity>2200MpaWater Absorption<20μg/mm3Water Solubility<0.8μg/mm3 Instructions For UseThe shoulder shall not be prepared in the area of corner and sharp edge. The shoulder shall be prepared in the shape of round inner edge or inclined surface.The space of 1mm is required to be reserved for the preparation of the cutting edge, so as to ensure that the resin block can achieve the ideal grinding effect in the process of cadcam. The preparation of the cutting edge should be at the enamel layer, and avoid the preparation at the point or area of stress concentration.Please Prepare teeth according to the diagramThe scan was performed with an intraoral scanner with an accuracy of 20-30 microns (Vinci oral scanner is recommended)to obtain the corresponding intraoral data model, and transfer the scanned data to the CAD design software for restoration design.Cad DesignRecommended exo cad design1. No interdetal design on the lingual side to ensure contact area2. Fill the tip of the abutment with a little wax, then scan and design.3. Increasing the cutting bur compensation value, can effectively alleviate the emplacement problem of the incisive position of the front teeth and veneer abutments be too sharp.Typesetting And Cutting1. Maintain equipment regularly, calibrate, clean, and lubricate. No shaking or abnormal noise during cutting. Replace parts in a timely manner.2. Before cutting, check whether the cutting bur sequence is correctly installed.3. Check whether the clamp is tightened before cutting to prevent the PMMA block from loosening during the cutting process, resulting in inaccurate data.4. Resin-cut burs can no longer cut zirconia products.Cutting InstructionUse the correct tool for grinding and polishing restorations adjustment is essential.Please observe the following polish handlers:1. Use resin griding head to trim the surface of the restoration. Use the following steps to make the surface of the restoration smoth.Coarse grinding: Sanding excess connecting rod after removing the conncting rod.Polishing: Make the surface texture smooth and delicate.2. Lay a towel on the work surface before sanding to prevent the restoration from being damaged by dropping the table.3. Using suitable grinding instruments, low rotation speed and light pressure can prevent layer and shape separation of the restoration.4.When grinding,do not make the resin too hot.5. If necessary, make personal adjustments.6. Try it on carefully during rough grinding and adjust the bite.7.When doing the next step, confim that the restoration has been carefully cleaned. And excess grinding dust has been removed.
Price: 42.99 USD
Location: Portland, Oregon
End Time: 2025-01-14T02:38:16.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: NobilCAM
Model: Pink PMMA Block
MPN: 22917
Country/Region of Manufacture: China
Intended Use/Discipline: Dental Laboratory, Dentistry
