Description: An instant upgrade or replacement for the printed electronic circuit used for tone control compensation in your Fisher tube gear. This listing is for 2 boards. There are two per stereo receiver, preamp or integrated amplifier, so one purchase is all you need for one piece of equipment. This model PEC is specifically used in lots of Fisher gear, including the 500C, 500B, 800C, 800B, 400 receiver, X100-B, X101-C, X101-D, X202-B, X202-C, Custom Electra IV Console, Philharmonic V Console and perhaps many other Fisher integrated amplifiers and consoles. The sound improvement is immediately noticeable. The components on this board are the same values and arrangement as appearing on the schematic, so no modifications to the original sound. Where the improvement happens is that these new components are miniature 2% tight tolerance film capacitors and 1% tight tolerance resistors. The original units used ceramic capacitor construction and resistor tolerances were much looser than 1%. Installation is easy, just snip the leads from the original part, insert the leads into the numbered holes and solder. There is also a ground plane built into the new part for additional shielding. A ground wire to the chassis ground shall be soldered into this hole I am showing in pictures, these boards installed in my 500B receiver, shown alongside the PEC’s they replace, as well as the receiver before the replacement. I thought the receiver sounded great previously, but installing these had woke this receiver up, every aspect that I thought sounded good in this receiver just immediately sounded better when these were installed.
Price: 39.99 USD
Location: Keyport, New Jersey
End Time: 2024-09-29T13:50:54.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 14 Days
Refund will be given as: Money Back
Brand: Fisher
Model: X101-D X202-B
