South Bend 9/10K, 11",13",14 1/2, 16", and Logan lathes Dial Indicator Holder!

Description: Lathe carriage indicator stop holder. Condition is New. Shipped with USPS Priority Available for models: (Please specify your lathe model when purchasing - or send Ebay message to seller ); IMPORTANT:Please specify your lathe model when purchasingorSend an Ebay message with the lathe model to seller. South Bend 9 (A,B,C)South Bend 10kSouth Bend Heavy 10South Bend 11South Bend 13 Logan 11Or ?? If your lathe is NOT one of the above listed then purchase and following below instructions for sending me your dimensions and lathe information. This is NOT a generic one size fits all and will perfectly clamp onto your lathe ways!!!! CAN BE CUSTOM MADE FOR ANY LATHE see dimension instruction image fill out dimensions and send to me! DOES NOT NOT NOT INCLUDE THE DIAL INDICATOR!!!!DOES NOT NOT NOT INCLUDE THE DIAL INDICATOR!!!!DOES NOT NOT NOT INCLUDE THE DIAL INDICATOR!!!! This is a 3dprinted "indicator stop" which I developed and tested on my South Bend 10K lathe.This will work on several lathes. South Bend 9 (A,B,C)South Bend 10kSouth Bend Heavy 10South Bend 11South Bend 13 Logan 11 If you have a different lathe, see the "dimension image" and send me YOUR lathe "way" dimensions and I will make an "indicator stop" to fit your configuration. This is a high quality 3dPLASTIC part which is BETTER AS PLASTIC than metal stops because it does the job and WILL NOT DAMAGE YOUR LATHE WAYS!It cannot scratch the way and IF accidentally OVERRAN it will simply slide on the way WITHOUT DAMAGE! The below video is a demonstration showing the use of a simple carriage stop with a dial indicator. This allows setting so that as the carriage reaches a particular location, the operator can witness the position using the dial indicator and disengage or stop the carriage.It is best to set a position of the stop so that when the carriage reaches the dial indicator probe, the advancement to final position is approximately 1 dial turn or less. This makes it easy to "know" when you are about to see the correct "0" point to stop the carriage feeding.It was very easy to stop within 0.005 - 0.010" of a position.This allows you to "manually" advance the carriage to finish the cut if desired.This indicator works very good.Also, you can set tension on the indicator/stop clamp so if an overrun occurs the indicator stop will simply slide. I'm fairly inexperienced at lathe operation but I made this to help me turn a backing plate for a new chuck.It was fantastic and easy to repeat many cuts and STOP within a few thousands of an inch from a preset location.This is great for internal boring and thread cutting! NOTE: This does NOT automatically stop your carriage. The operator MUST manually stop or disengage the carriage feed when desires. The "dial indicator" (NOT SUPPLIED) provides a precise position for carriage stop. DOES NOT NOT NOT INCLUDE THE DIAL INDICATOR!!!! Dial indicator bore hole is 0.375 and IF needed a set screw can be used to secure it.MY dial indicator was a SNUG slip fit so I did NOT need to use a set screw to retain the indicators position IN the body of the stop. Video click below image!(does not have dial indicator retaining screw installed) South Bend 9/10K lathe carriage stop Indicator - YouTube Video will open in a new window Using the eBay App? Paste link into a browser window:

Price: 34.95 USD

Location: Cross Plains, Tennessee

End Time: 2023-11-20T21:02:00.000Z

Shipping Cost: 4.5 USD