Description: These will come with both Aluminum and Stainless Post.Your Choice of either 100 Total Grains or 58 Total Grains Front Of Center Outsert System (Patent#US10203185)Quantity per pack 12 EachThe Rampage Front Of Center Outsert System F.O.C.O.S (Patented) is a revolutionary product in the Components category. This outsert system is designed to improve the performance and accuracy of arrows by shifting the weight forward to enhance front-of-center balance. Its patented design ensures superior durability and easy installation. By optimizing the F.O.C.O.S system, this product guarantees enhanced arrow flight and accuracy, making it a must-have for serious archers.The F.O.C.O.S is made of 3 parts. One is a black anodized 7075 T6 aluminum alloy outsert. Two is a Stainless steel Retention post that also acts as a footer inside the shaft. The third part is the 3/32 allen head retention screw that allows for the Outserts to either be screwed on or screwed and glued.(Not Tattooed) This system has been tested to over 550 Pounds per square inch of pull and they stay on! If you are looking for maximum penetration, Maximum F.O.C and shot after shot performance then the deadly combination of the Rampage arrows then the F.O.C.O.S is sure to be a hit! Rampage COMPLETE Focus System Weighs 100 Grains:Rampage F.O.C.O.S Outserts use FOCOS Brass Weights if you are adding extra weightTo install the F.O.C.O.S SystemSelect the right outsert for the right shaft.Glue in Stainless steel retention PostDry fitting is recommended on all components. Slide Outserts over shaft and spin test (if you prefer)If Outserts does not fit that is OK. Get some 100 Grit sand paper and lightly sand the shaft in a circular motion until the outsert fits fairly snug on shaft. Start slowly so you don't remove to much off the arrow.You should have approximately 3/4 of an inch insertion on Aluminum OutsertsWipe dust off of the shaft with Clean paper towel. (No Cleaners are recommended)Again, Spin test to ensure concentricity.Use a Silver or Black Sharpie and mark the Shaft and the Outsert for perfect alignmentSlide outsert over shaft and use the 3/32 Head retention Screw and Lock the Outsert in place!If using glue See steps 11-15 .We have tested Our fletching glue, insert/outsert glue and epoxy and all of them work great.Apply a even amount of glue around the shaft to ensure you get enough glue in them to hold.Slide Outsert On shaft rotating to make sure Glue/Epoxy is evenly dispersedUse the 3/32 Head retention Screw and Lock the Outsert in place! Loctite Purple or Blue recommendedOnce The outsert is glued on Screw is installed stand the arrow on the nock end to dry.
Price: 48.99 USD
Location: Palmyra, Missouri
End Time: 2024-09-13T13:29:43.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: Black Eagle
Spine Size: 300
MPN: 32615
