PZ20 Carburetor Gaskets For Aprilia BMW Honda CB750 CB200T Kawasaki Ninja ZX10R

Description: Shipping from the nearest USA warehouse. And please understand sometimes we ship from USA warehouse at other states if the nearest warehouse is not available. Please check if the part number, Fitment Model and Listed Pictures above fit your need or not before placing your orders. Contact us freely, if you have any question or problem. We will back to you within 1 business day. Please use the Ctrl+F to search the Part Number / Models that you need. And if you have any question, please don’t hesitate to contact us. Description:Inner Diameter (intake side): 20mm / 0.79 inchMounting Center to Center: 48mm / 1.89 inchOuter Diameter(air filter side): 33mm / 1.3 inch Interchange Part Number:PZ20 Fitment:Kazuma Meerkat 50cc ATV CarburetorKazuma Falcon 90 ATV CarburetorKazuma Viper 110cc Dirt Bike CarburetorChinese 90cc-125cc ATVs, Go Karts with Horizontal EngineFits for most 49cc, 50cc, 70cc, 90cc, 110cc, 125cc, 135cc 4-Stroke engine Chinese made ATV, QUAD, Go Kart, Dirt Bike, like TaoTao, SUNL, Buyang, Coolsports, AIM-EX, Roketa, Kazuma, etc.TaoTao, Buyang, Coolsport, Lifan, Kazuma, SUNL, Honda, Redcat, Eagle Tips:1- Unscrew and pull the top of the carb off with the cable and there will be a slide with the needle in the center.2- Disconnect the cable through a small slot in the side of the slide.3- Now you can take the needle out from the slide.4- The needle will have a very small e clip in a slot on the needle. The needle will have 5 slots. Lowering the clip is richer the and raising the clip will lean it out.5- Put the clip on the lowest setting for cold weather. DO NOT DROP THE CLIP! They are very small and hard to find.6- Reverse the process with installing the needle back into the slide, installing the cable, slide the slide back into the carb and screw the cap tight. Notice:1. Make sure the air cleaner is clean.2. make sure the choke lever is OFF while running.3. Warm the engine up for 3-5 minutes.4. Turn the mixture screw clockwise until fully closed,then turn the mixture screw 2 full turns out.5. Adjust the idling screw until the engine idles EASILY.6. Turn the mixture screw slightly clockwise andcounterclockwise until the highest engine REVs is obtained. NOTE:1. Please be very careful to check our photos, make sure the photos showed above is same as the part you wanted.2. Please compare the part number with your Original One before purchasing!(If you are not sure, please feel free to contact us, we are always here to help!) △This is Non-Original Aftermarket Parts, please check the size for compatibility before ordering it.△Installation instruction is not included. Package includes (as pictured):1x Carburetor2x Gaskets1x O-ring

Price: 12.94 USD

Location: CA/NJ/KY/TX

End Time: 2024-02-25T02:46:27.000Z

Shipping Cost: 0 USD