PLUG & PLAY USA HAM BUILT HAM & CB Radio Monoband Dipole Antennas for 10

Description: PLEASE ORDER BY MODEL, ie. DP10 for 10 meter antenna, DP20 for a 20 meter antenna, etc. Wire color varies. These dipoles have been built for reliability and performance. Each of these antennas have been optomized for a single amateur band including CB 11 meter band, 10 thru 20 meters rather than a multi-band antenna which yields lower efficiency for both transmitting and receiving. They are built to be used with 50 to75 ohm feedlines and can be used with full legal amateur power and will provide a close match when properly installed, (low swr) to any amateur transmitter/tranceiver including low power QRP units. Materials include 14ga stranded pure copper elements, poly insulators and incapsulated UHF SO-239 termination. There is no exposed metal hardware to corrode or rust from exposure to extreme weather conditions. The encapsulated termination prohibits the collection of condensation eliminating intermittant and high resistance connections which can cause intermittant or even no reception and poor efficiency. It is my own experience in using and building dipole antennas for more than 50 years that this type of antenna rates high in performance for not only stateside communications, but also dx work. As with any antenna, proper installation is important for best performance. If you have a favorite or mostly used frequency in the band, we will cut the antenna for resonance in that portion of the band. Any questions or comments please send a message . NOTICE: For safety reasons this antenna is constructed using INSULATED wire. DO NOT install your antenna over/under or near power lines, even though the use of insulated wire should prevent severe injury or even death from electric shock.

Price: 59 USD

Location: Springfield, Missouri

End Time: 2024-10-10T15:06:40.000Z

Shipping Cost: 0 USD