M-Factors 2.5 Inch Internal SSD 32GB - 128GB MLC NAND SATA III Up To 550MB/s

Description: 2.5" SATA MLC SSD 2.5" SATA SSD delivers all the advantages of Flash Disk technology with Serial ATA I/II/III interface and is fully compliant with the standard 2.5" form factor. The device is designed based on the standard 7-pin interface for data segment and 15-pin for power segment. The 2.5" SATA runs at a maximum operating frequency of 300MHz with 40MHz external crystal. Based on Toshiba's MLC flash (with external DDRIII 256MB/512MB cache enabled and measured by CrystalDiskMark v3.0), Emperor 900 can reach up 260-550MB/s read as well as 200-350MB/s write high performance. Moreover, the 2.5" SATA SSD enables hot-swapping when removing, replacing, or upgrading flash disks while also providing low power consumption in comparison to traditional hard drives.Offering improved Read/Write performance, SMART technology, reliability, and low power consumption, 2.5" SATA SSD is an ideal storage for embedded systems.HIGHLIGHTSEasy installationToshiba MLC NAND FlashCompliant with SATA Revision 3.0Compatible with SATA 1.5Gbps, 3Gbps, 6Gbps interfaceNCQ support up to queue depth=32Supports power managementSupports expanded register for SATA protocol 48 bits addressing modeEmbedded BIST function for SATA PHY for low cost mass productionSupports all types of MLC large block: 16K/page NAND FlashSupports 2.3 interface and 3.0 interface: 5 channels at maximumContains 4pcs to 16pcs of TSOP FlashCorrects up to 72bits error in 1K Byte dataSupports SMART and TRIM Commands ItemSpecificationSpecificationInterfaceSATA 6Gbps and 3Gbps, 1.5Gbps interfaceONFI 2.3 and ONFI 3.0 Interface support Electrical5V (Operating Voltage)Form Factor2.5" SATASizeOption 1: 100mm*69.85mm*7mmOption 2: 100mm*69.85mm*9.5mmweight~2oz/0.13lbsCapacity32GB to 128GBPerformanceSequential write200-350 MB/sSequential Read260-550 MB/sPower DissipationIdle105mW Active 2560mW DependabilityTRIM support NCQ support Firmware Update support MTBF>1,000,000 hoursS.M.A.R.TsupportBad-Block ManagementAdvanced bad sector management algorithmsWear-levelingStatic and dynamic wear-leveling algorithmsECCBuilt in hardware ECC circuit (up to 72bit/1KB)EnvironmentStorage temperature-40~85℃Operation temperatureStandard0~70 ℃ Vibration 80Hz~2000Hz/20G Shock1500G/0.5msHumidity90% under 40C RoHS CompliantYesWarranty2 years

Price: 25 USD

Location: Irvine, California

End Time: 2024-02-19T18:17:15.000Z

Shipping Cost: N/A USD