Large Ryobi Charger Holder for Ryobi Link Wall Rail garage organizer

Description: Large Ryobi Charger Holder for Ryobi Link Wall Rail This holder provides a strong mounting area for your large or long Ryobi Charger to the Ryobi Link Wall Rail. The holder slides in and mounts securely to the Link Wall Rail and can span to an additional Wall Rail below it (or not). Screws (not provided) may be installed in the center slotted hole(s) to additionally secure it. There is a notch in the back to span across raised areas between Ryobi Link Wall Rails. The 6 raised holes allow for a variety of large/long chargers to be installed with a short wood screw. See the photo for the spacings of the holes including a list of chargers that it will accommodate. We recommend short wood screws that are 1/2" long. No wood screws are included. This may be mounted on 1 or 2 Ryobi Link Wall Rails. If mounting on only 1 Rail, push out and remove the center block and remove the included nut & bolt with a Phillips head screwdriver. Attach this block using the nut & screw to the back of the bottom. See photos. This provides blocking support at the bottom to the wall for installations on only 1 Ryobi Link Wall Rail. Thus your long Ryobi Charger will not rock or push back when mounted on 1 rail. If mounting on 2 rails, this block can stay inset and is not used. For smaller (or commonly sized) Ryobi chargers please see our Small Ryobi Charger Holder which attaches to only 1 Ryobi Link Wall Rail. 3 wire clips for the Ryobi Link Wall Rails are included. These press into the horizontal channels to organize your wires or cables. If you do not need them, they clip into each other as well as the Charger Holder for storage. Additional wire clips may be purchased separately. No Ryobi Chargers are included. Chargers shown in photos are for reference only. It is 3D-printed in black PLA plastic. It is 9.3" x 7.2" x 0.7" (236mm x 182mm x 17mm). This item is 3D Printed in PLA plastic which is made from a renewable resource. It’s biodegradable and eco-friendly. These are lightweight and due to the printing process, there may be some imperfections. 3D Printing involves the heating and depositing of material on a flat board one layer at a time. Each model is custom printed to order. I print these as a hobby and am not a large scale manufacturer. They are all printed in the USA.

Price: 15.95 USD

Location: Lexington, Kentucky

End Time: 2024-09-21T13:51:01.000Z

Shipping Cost: 0 USD