Inlaying the Surface Knife Clip DIY Accessories Brass Washers Gaskets

Description: Product Description Product Information CNC lathe production, using brass H62, surface steel stamp English 45 AUTO FEDERAL, with a 416 stainless steel screw. It is suitable for inlaying knife handle surface decoration, folding knife clip decoration, Zippo lighter decoration and other domestic mainstream Fidget spinner and other craft products, which can bring this product to your products to a higher standard. Using installation prompts To install this gasket on your product, it must be flat. In addition, it is necessary to drill a 2.3MM hole in this plane with Fried Dough Twists, and then use a manual tapping tool to stir up an M2.5 thread. Finally, insert the screw into the washer and tighten it with a T6 ring wrench. If there is no tapping tool equipment available, the cutter can drill a 2.5MM hole to directly insert the screw, provided that it is tightly glued. About UsPaymentShippingContact UsWe accept all verified payments from ebay.Orders will be shipped after receiving cleared payment.Payment due within 7 days after auction ends and for buy it now listings.

Price: 5.99 USD

Location: shenzhenshi

End Time: 2024-12-31T19:02:02.000Z

Shipping Cost: 0 USD