Fluke RPM80 Automotive Inductive Pick-up/External Trigger

Description: Fluke RPM80 Automotive Inductive Pick-up/External Trigger Allows RPM measurement from secondary side of spark plug ignition systems As with any inductive pickup, the RPM80 may not be compatible with all ignition systems Compatible with Fluke 78 and 88 Automotive Digital Multimeters Used. Almost new, used once. Complete with original packaging Small abrasions on the cable and the red terminal boot. I bought this pickup to accompany my Fluke 88V multimeter. Unfortunately, during my first use of the pickup, the meter fell from where I had it perched and the lead cable on the pickup rubbed the crank pulley on a running engine. The pickup still functions perfectly but at the time I was in a spendy mood, so I replaced it. The one abrasion on the cable worth patching will be very easily repaired with some electric tape and I would suggest first some liquid electrical tape for good measure. I left the cable un-repaired in order to show the extant of the damage. The full extent of the damage is shown in the photos. There is an abrasion on the outer insulation about 21” from the pickup that does not go through the insulation and is about 9/32” x 1/8”. The top of the red terminal boot is abraded. There is an abrasion within ½” of the black terminal boot that does not go through the insulation. There are a couple of abrasions on the black lead, about an inch from the terminal boot. One of these breaks through the insulation and exposes the wire. Examination under 25 power magnification shows that one strand of themulti-stranded wire is damaged. This is the only spot on the cables that, in my opinion, would benefit from a repair to the insulation. The current MSRP for this pickup is $146.99 per the Fluke website. Model#: Fluke RPM80 Part#: 880849 UPC#: 0 95969 1205 8

Price: 60 USD

Location: Torrance, California

End Time: 2024-10-01T01:17:39.000Z

Shipping Cost: 9 USD