Earthquaker Devices Blumes Low Signal Shredder Overdrive Pedal

Description: DJ GEAR INSTRUMENT GEAR LIVE SOUND RECORDING MICROPHONES HEADPHONES ACCESSORIES SOFTWARE LIGHTING BUNDLES Authorized Dealer - Full Warranty Earthquaker Devices Blumes Low Signal Shredder Overdrive Pedal Overdrive Pedal - Brand New - Description Blumes is an all-analog tri-mode soft-clipping bass overdrive that carries the torch of the classic screamer circuit but has a voice all its own. While embodying most of the characteristics and features of our beloved Plumes Small Signal Shredder, this modified circuit has double the gain and a deeper bass response to retain all the low ends. It utilizes internal bipolar power, which gives you more dynamics and all the headroom you could ever desire. The end result is a three-dimensional tone with added clarity that really pushes a nice tube amp over the edge. Controls Gain: This controls the amount of drive. Tone: More bass to the left, more middles in the middle and more treble to the right. Level: This controls the output volume. Clipping Modes (3-Way Toggle): Symmetrical LED clipping: more crunch and compression. No clipping: wide-open OpAmp drive for a clean boost. Asymmetrical silicon diode clipping: more transparency with a loose feel. Design Notes As a bass player, we understand that you often feel neglected within the hierarchy of band constructs, despite the fact that you hold down the rhythmic foundation and make everyone sound better. So that’s why this marvelous yellow box was created specifically for you. But fear not, 6-stringers, this is also the perfect pedal for all of your deep overdrive needs, especially you drop-tuned masters. We see you. This all-analog tri-mode overdrive with soft clipping carries the torch of the classic screamer circuit but has a voice all its own. And thanks to its bipolar power, you'll get more dynamics, clarity, and all the headroom you could ever desire. The end result is a more three-dimensional tone with added clarity that really pushes a nice tube amp over the edge. While embodying most of the kick-ass characteristics and features of the Plumes, we went ahead and modified this circuit with double the gain and deeper bass response to retain all the low ends. At lower gain settings, you’ll get all of the crunchy tones you love about the original, but once you get above noon on the Gain control, that’s where the similarities stop. Now you’re in the bass country, baby! Get ready to shake some walls and field some angry calls from your neighbors (just send them to voicemail). And much like the Plumes, this pedal offers three different clipping options for your desired low-end face melting needs. Mode 1 is a symmetrical LED clipping that utilizes a pair of light-emitting diodes. This is the crunchiest setting the Blume's has to offer. This signal is less compressed and way more open with tons of output for when you really want to go wild. Mode 2 is a clean pure OpAmp gain boost mode. This eliminates the soft clipping diodes altogether and leaves you with a straight OpAmp drive. This will be the loudest output with the fullest frequency response and can be used as a clean boost when the Gain control is set below 11 o’clock. Mode 3 is an asymmetrical silicon diode arrangement similar to the stock screamer but with more output and clean clarity, which provides a more transparent tone. Using this mode gives a warmer low-end response and lower output. It’s fuzzier with half the output and is the most compressed. If you like the fuzzy ends of distortion with a clean undertone, you’ll love this setting. We guarantee it. Features/Specs Dimensions 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs Current Draw 25 mA Input Impedance 10 MΩ Output Impedance 100 Ω Flexi-Switch Technology This device features Flexi-Switch Technology! This relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching. For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass. For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch the effect will be bypassed. Since the switching is relay-based, it requires power to pass the signal. Power This device takes a standard 9-volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains, and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES! We are authorized dealers for all these brands. Click a logo to see our listings. ProAudioStar is also not responsible for any taxes, local duties, or fees outside of the USA and those are not included in the sale price or ship charge. If an item is refused by the buyer, ship costs to and from the destination in which the item was shipped to are not refunded. Please note the cost of return shipping is usually double of what the original ship cost. Shipping is not free to HI, AK, and PR. FREE SHIPPING ONLY TO THE LOWER 48 STATES. We provide free shipping to the contiguous 48 United States, on most items. Shipping fees to ALL OTHER LOCATIONS will be calculated individually and added to customer invoices. ProAudioStar is also not responsible for any taxes, local duties, or fees outside of the USA and those are not included in the sale price or ship charge. In the event that the customer refuses a shipment, all shipping costs to and from the country or State in which the item was shipped to are not refunded. Please note, in some cases return shipping can cost as much as double the original ship cost. We operate a 30-day return period. Items must be returned with all original packaging as well as all included items. Items that are not returned in original, resalable condition are subject to a 15% restocking fee. We charge a 15% restocking fee on returned items only if the item is clearly used and or the packaging is tarnished. A 10% re-stock is more likely if the unit comes back in mint condition. The ship cost we paid to ship your item will be deducted as well. In some cases restock fees and ship costs can be applied as a store credit. We will exchange a defective unit for the same unit within the 30-day period. After that period, you will have to work directly with the manufacturer for warranty service. Items that can not be returned include: software, units with contents or packaging that is damaged/missing, and items that are considered for personal use (such as earphones, headphones, microphones, instrument mouthpieces, harmonicas or other items that you wouldn't want to purchase if someone else had previously used them). Also, Items which we do not normally stock (i.e. "Special Orders", discontinued products, close-outs, used products, etc.) are non-returnable. We strongly suggest that you check your order after receiving it to be sure that it is in proper working order. Please contact us for a Return Authorization before returning any items.

Price: 84.15 USD

Location: Winchester, Virginia

End Time: 2024-09-09T14:02:47.000Z

Shipping Cost: 0 USD