Diablo Controls DSP-50 Probe Kit Vehicle Loop Detector 75ft Lead Wire

Description: Diablo Controls DSP-50 Probe Kit Vehicle Loop Detector Diablo Controls DSP-50 Probe Kit Vehicle Loop Detector with 75ft Lead Wire FEATURES The Diablo DSP-51AT detector can be configured to provide an output for tailgating vehicles or as an accurate vehicle counter. The detector has enhanced Anti-Tailgating features that allow the end user to select the allowed number of vehicles through a secured access. The enhancements are not only for tailgating but also for providing an accurate vehicle count output as a secondary feature. The Diablo DSP-51AT was designed for use with current typical loop configurations and sizes used throughout the industry. The simplicity of the set-up and operation allows the end user to implement the detector without special training devices. OPERATION The Diablo DSP-51AT is mainly a standard vehicle loop detector. But that’s where the similarity ends. Its built-in secondary functions are exclusive anti-tailgating and vehicle counting software. The two modes are selectable from a front panel DIP switch. In the anti-tailgate mode, the software compares the signature versus the number of legal vehicles input. If there is any discrepancy, the secondary output is enabled indicating a tailgating incident. In the counting mode, the secondary output is pulsed once for every vehicle entering the loop system based on a proprietary signature algorithm. FRONT PANEL SELECTABLE SWITCHES SENSITIVITY SWITCH This detector has a 10 position rotary sensitivity switch. The unit is shipped in the “5” position which is the normal sensitivity level. Sensitivity can be adjusted up and down from this level to accommodate different street loops. FUNCTION SWITCHES The detector has a 6-position DIP switch to incorporate the following functions. DIPSWITCHES 5 and 6 – Frequency One of four operating frequencies can be selected by changing these two switches. DIPSWITCH 4 – Failure Operation OFF = Fail Safe operation. ON = Fail Secure operation. DIPSWITCH 3 – Failure Output Polarity OFF = Fail output low indicates loop failure ON = Fail output high indicates loop failure DIPSWITCH 2 – Operating Mode OFF = Anti-Tailgating Operation ON = Counter Operation DIPSWITCH 1 – Anti-Tailgating Test Toggle switch to indicate number of vehicles in inbound queue. INDICATORS Green LED solid ON is power OK. Fast blink = “Shorted” loop. Slow blink = “Open” loop circuit. Red LED's OFF = No Detect. ON = Detect Blue LED On = Output B On Yellow LED OFF = Unarmed. ON = AT armed Outputs - Three separate solid state (normally open collector) outputs – 30 milliamps maximum and 20volts maximum. Output pins – (looking into the connector – Right to left.) 1 Loop 2 Loop 3 Power input “+” 4 N/C 5 /AT input 6 Output B 7 Fail 8 Output A 9 Power input “+” 10 Power (and logic) Common Operating Temperature - -35°F to 165°F (-37°C to 74°C) Power - 10 to 30 Volts D.C. ( 30 mA. max at 12 volts) Enclosure - Impact resistant, high temperature plastic. H - 2.375” (60.4 mm) W – 0.86” (22 mm) D -2.25 ” (58mm) Payments & Returns Policy

Price: 169.95 USD

Location: Miami, Florida

End Time: 2024-08-13T17:56:18.000Z

Shipping Cost: 0 USD