Compact Alignment Stand for Garmin Approach R10

Description: This listing is for a 3D-printed Alignment Stand for the Garmin Approach R10 portable golf launch monitor. Accurate data from the Garmin R10 starts with proper alignment of the launch monitor and this compact stand will help you achieve higher precision of your R10 placement. Highlights/Features: • Uses inexpensive fiberglass reflective rod (Not included) up to 8mm in diameter for visual alignment. You can find these at most big box hardware stores like Home Depot or Lowes for $3-4. (The yellow 48" one I use was $2.78 from Home Depot. 72" rods are also available at Home Depot.). • Slight footing indentations for the Garmin R10 help with consistent placement of your Garmin R10 onto the stand. • Compact size allows the stand to fit in the accessory compartment of the Garmin R10 Case (not included). Designed & Made in USA; Shipped from USA (California) Important Notes: • Stand is 3D printed and will have inevitable 3D printed surface blemishes. • Do not store in locations that can exceed 125°F for prolonged periods (like inside of a car on a hot day). • Garmin R10 launch monitor is Not included. • Garmin R10 case is Not included. • Alignment stick / rod is Not included (again, I highly recommend using the fiberglass reflective rods at the big box hardware stores instead of the ones marketed for golf alignment as the latter is orders of magnitude more expensive than the former) • I'm an avid golfer and may make improvements to the design so the unit you receive may have updated revisions not present at the time photos were taken. • I only sell 3D printed products that I've designed from scratch.

Price: 15 USD

Location: Dublin, California

End Time: 2024-02-17T08:07:07.000Z

Shipping Cost: 4.75 USD