Carbon Fiber Vinyl Decal Hood Wrap for Dodge Charger SRT Hellcat 2015-2019

Description: PRE CUT BLACK CARBON FIBER HOOD WRAP FOR: Dodge Charger SRT HellCat (2015-2019) PRODUCT DETAILS:★ Highly conformable and great cold stretch, better than most. Excellent lifting resistance.★ Use it right out of the box, no need to print or apply an overlaminate.★ Improved warranty up to 7 years vertical and 2 years horizontal in most parts of the U.S.★ Excellent slideability and initial tack for easy snap-up, but reliable tack during installation.★ Non-visible air release channels with excellent air flow to prevent bubbles.★ Dual cast 3.5 mil wrap film features high conformability and great cold stretch, up to 7 year vertical and 2 year horizontal warranty, removable, pressure activated adhesive with non-visible air release channels. The gloss colored films also come with a protective film layer to reduce surface impressions and scratches. It can remain on the wrap film throughout the installation process, and then removed easily. The 60 inch width allows you to wrap almost any section of a vehicle without seams.INSTALLATION INSTRUCTIONS★ Cleaning the Vehicle Properly Before Applying Film.Cleaning the application surface properly is one of the most important steps to a good application. Wash and dry the vehicle thoroughly. Wipe the application area and a large area around it with a solvent-based cleaner, wiping dry as you work. Wipe again with a 2:1 mixture of Isopropyl Alcohol (IPA) and water, wiping dry as you work. For complete details, please read 3M Instruction Bulletin 5.36. Alternatively, use 3M™ Surface Preparation System and lint-free paper towels for cleaning the application surface. After cleaning make sure that the application surface is completely dry.★ Using Masking Tape for Alignment.Always use masking tape to mark alignment. Do not use a grease pencil. Its waxy core can become embedded in the film’s texture, andattempting to remove it may damage the texture.★ Covering the Edge of the Squeegee to Reduce Scratches.The unique finishes on film series 2080 are sensitive to installation scratches and require careful handling during installation. 3M recommends using a high-density felt squeegee, or covering the edge of a 3M™ Applicator PA1-G (gold) with the “loop” side of 3M™ Scotchmate™ Reclosable Hook and Loop Fastener - Loop portion SJ-35231 or PTFE tape. Another option is to use a squeegee with a suede or nylon wrapped edge. Alternatively, use 3M™ Application PA1-G (gold) squeegee with thin, soft micro fiber sleeves.★ Using a Heat Gun, Not a Torch, for Heating the Film.Heat the film only with a heat gun - never a torch. A torch is likely to alter the appearance of the finish permanently, which cannot be repaired.★ Using 3M Roller Tools3M offers several roller based tools to help get the job done. 3M™ Rapid Roller Applicator CPA-2 is for flat areas, such as the hood or roof. 3M™ Roller L, 3M™ Roller S and 3M™ Vehicle Channel Applicator Tool VCAT-2 have specially shaped rollers to help conform heated film into channels and recesses. Read more about these tools in 3M Instruction Bulletin 5.36.★ Using Application TapeFilm series 2080 features a dual cast construction that is 3.5 mil thick. It has just enough rigidity to allow easy installation without anoverlaminate or application tape. Due to the film’s texture, application tape may not work well with cut and prespaced graphics. Wrap shops may choose to test and approve an application tape. 3M™ Prespacing Tape SCPS-55 is a good one to try.

Price: 249.95 USD

Location: Las Vegas, Nevada

End Time: 2025-01-17T00:29:25.000Z

Shipping Cost: 0 USD