BMW E82 E90 E92 Subframe Bushing Removal puller Tool M3 130i 135i 330i 335i N54

Description: Subframe Bushing Removal Tool for all of the following chassis: E82, E84, E87, E88 E90, E91, E92, E93 Used to remove factory bushings from above platforms. Also doubles as installation tool for OEM M3 bushings, delrin bushings, or solid aluminum bushings. To remove the factory bushings you will have to drop the subframe but not fully remove it. You need enough access to the top of the bushings to put the washer plate on and thread the nut and locknut onto the threaded rod. For removal of the bushings at the rear of the subframe, you use the tool less the large tanged washer. For bushings in the front of the subframe you use the tanged washer to catch the narrow lip of the subframe holding the bushings. The rear bushings are overall easy. The front bushings without the use of this tool would be extremely difficult as there is no real area to push against the subframe except for the two narrow edges of the subframe exposed thru notches molded into the bushing. Once bushings are removed you can generally install aftermarket split urethane bushing by hand. To installing M3, Delrin, or solid aluminum bushings you will have to fully remove the subframe to allow more room on the top to use the tool to pull the bushings back into place. Washers are cut from high strength steel. Bronze oil impregnated sleeve & thrust bearings are installed on both sides of the main cup to aid in an effortless removal/ or installation. They also serve to protect the threaded rod from damage as it slides thru it. Flange nuts are provided to evenly distribute the forces on bronze thrust bearings and to help everything stay as parallel as possible during the process. A grade 8 lock nut is provided so you can keep the appropriate end from not turning. Threaded rod is industrial quality B7 grade which is approx 2.5x stronger than a traditional hardware store threaded rod (120k tensile vs 50k tensile psi) https://www.ebay.com/itm/334790214077 This is a link to a replacement rod if neededNEED A WAY TO SAFELY SUPPORT YOUR CAR WHILE DOING THIS JOB? SEE OUR BMW SPECIFIC JACK STAND ADAPTERS IN THE LINKS BELOW https://www.ebay.com/itm/333512163307 This is our adapter for 1 1/2 - 2 1/2 ton jack stands https://www.ebay.com/itm/333881087249 This is our adapter for 3-4 ton jack stands (Most common)https://www.ebay.com/itm/333619330665 This is our adapter for 4-6 ton jack stands All adapters are made with pride in the USA from 11ga (1/8") zinc plated steel and 1/2" 6061-T6.VISIT OUR STORE TO SEE ALL OF OUR PRODUCTS (It's the little blue door next to our feedback count, next to username)

Price: 87 USD

Location: Dayton, Ohio

End Time: 2023-12-14T14:23:42.000Z

Shipping Cost: N/A USD