[ Adafruit ] Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070

Description: This breakout board is the simplest way to create a project with multiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed. Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once. Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout. - note that this board uses the chip in 'standalone' mode only, it cannot be used in I2C mode.

Price: 10.95 USD

Location: Columbiana, Ohio

End Time: 2025-01-01T20:29:41.000Z

Shipping Cost: N/A USD

Product Images

Item Specifics

Return shipping will be paid by: Seller

All returns accepted: Returns Accepted

Item must be returned within: 30 Days

Refund will be given as: Money back or replacement (buyer's choice)

Return policy details:

Brand: Unbranded

MPN: Does not Apply